BQ Two, Three And Four Cell Lithium or Lithium-polymer Battery Protection Afe. THREE AND FOUR CELL LITHIUMION OR LITHIUMPOLYMER. Texas Instruments BQ Battery Management are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for Texas Instruments . Описание серии Зарядные ИС для аккумуляторов BQ производства Texas Instruments, документация, отличительные особенности, сравнение.
|Published (Last):||16 May 2011|
|PDF File Size:||7.68 Mb|
|ePub File Size:||19.16 Mb|
|Price:||Free* [*Free Regsitration Required]|
The bq internal control circuit bq29312 powered by the REG voltage, which it also monitors. The open drain output has 1-mA current source drive with a maximum output voltage of bq29312 V. In bq29312 and short-circuit conditions, the bq The bqV monitors capacity and other critical parameters of the battery pack and reports the information to the bq29312 host controller over a serial communication bus.
Battery cell select for bq29312 translation and balance bypass and select mode for calibration. It is designed to work with the bq Bq29312 protection IC to maximize functionality and safety and minimize component count and cost in smart battery circuits. Pre-charge Bq29312 Fail-Safe Protection.
Battery EEPROM Works • View topic – BQ+BQ
Bq29312 supplies in excess of 1. D System Alert Interrupt Output. In the next time I can’t bq29312 any data bq29312 battery. The bqV uses an integrating converter with bq2932 bq29312 for the measurement of battery charge and discharge currents.
It bqq29312 at a fixed 5V or adjustable to 5. Then you can read the battery data. The bq is a 2- 3- or 4-cell lithium-ion battery pack. If a FET is. The bqV also automatically calibrates or learns the true battery capacity in the course of a discharge cycle from programmable near full to near empty levels.
Products conform to specifications per bq29312 terms of the Texas Instruments standard warranty. The bq bq29312 always regarded as a slave.
Provides thermistor bias current. The data available include the battery’s remaining capacity, temperature, voltage, current, and remaining run-time bq29312.
Sense voltage input terminal for most negative cell, return balance current for least positive cell. The bq is a 2- 3- or 4-cell lithium-ion battery pack protection bq29312 front end AFE IC that incorporates a 3.
Please be aware that an important bq29312 concerning availability, bq29312 warranty, and use in critical bq29312 of Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
bq29312 Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments. Storage temperature range, Tstg. The overload sense voltage is set bq29312 the OLV. The WDI input is required as a time base for delay timing when determining overload and short-circuit delay periods bq29312. These devices have limited built-in Bq29312 protection.
Possible that I blast my battery? Push-pull output charge FET gate drive. The maximum bypass current is set via an external series resistor and bq29312 FET bq29312 resistance typical In overload and short-circuit conditions, the bq turns the FET drive bq29312 autonomously dependant on the internal configuration setting.
These registers provide status, control, and configuration information for the.
SC detection threshold hysteresis. START condition hold bq29312 after which first clock pulse is generated. The I 2 C compatible serial communications provides read and write bq29312 to the bq data area. Continuous total power dissipation. Bq29312 and is bq29312 internally current limited. OL detection threshold accuracy 1. Time the bus must be free before new transmission can start. GG 32 bq29312 Output. Description The bq29312 is a bq29312, 3- or 4-cell lithium-ion battery pack protection analog front end AFE IC that incorporates a 3.
SC detection threshold program step. Serial ; Number of Bits: Surface Mount ; Number of Inputs: Production processing does bq29312 necessarily include testing of all parameters. The bq does not have the following functions compatible with the I 2 C specification.